Info adapter + steering wheel controls Fiat 500X 2015 – 2021 CTUFT02

Description

The infotainment adapter will retain several vehicle display functions after replacing the factory radio or navigation system.
Vehicle-specific settings are available and will be displayed on the newly installed radio.

The SWC buttons are necessary to access the Infodapter configuration menu.

Not all features will be retained, such as trailer assist, E-Call, etc.

Please check your factory radio and vehicle settings for available settings before installation.
Test all functions before final installation.
Also check our listed OEM head units and compare the wiring harness connectors shown with those in your vehicle to ensure visual and technical compatibility.

• For vehicles with steering wheel remote controls
• CAN bus
• Connection: 52-pin Fiat connector
• Call up menu settings > connect purple/white reverse gear output
• Visualize menu settings > Connect and configure the yellow Cinch(m) to the rear view camera input
• Vehicle Settings and Vehicle Information > Reflected on Retrofit Monitor Rear Camera Input
• Vehicles with voice control and telephone buttons
• Depending on the OEM vehicle equipment and software:
• Not all vehicle settings are supported
• Not all vehicle features are supported
• Not all vehicle information is visualized
• Driving assistance system not supported
• Vehicles with OEM Rear View Camera OEM Plug:
• Reversing Camera Adapter OEM Camera 52Pin Fiat/32Pin Ford > Article: 771000-2000
• red: Pin 31 Video+
• white: Pin 32 Video –
• Black: Shielding Pin 33

Make and model:

• Fiat 500X (ZAF 334) 01/2015 – 08/2018
• Fiat 500X (ZAF 334) 09/2018 – 2023

Note: Only for vehicles with telephone button and voice function.

The following signals are provided:

Re-imported vehicles or vehicles with different software may have incompatible features.

• red: ignition terminal +12V 15
• orange: lighting terminal +12V 58
• purple/white: +12V feedback signal
• pink: speed signal
• green: handbrake signal ground GND
• Steering wheel remote control
• Supported vehicle settings
• To enter the settings, connect the feedback output (purple/white) to the HU
• To visualize the settings, connect and configure the HU reversing camera input
• VP1 OEM HU Setting:
• When the odometer is flashing, you need to enter the Infodapter menu.
• Press and hold the speech button for a few seconds from the main menu go to Infodapter settings.
• Preferences
• Configuration menu
• try several settings from 0 to 3
• (most commonly used setting 2, try this first)
• After changing the settings, you should restart the interface by disconnecting the power and leaving the car in standby mode for 15-20 minutes. This will allow the interface to send a new command to the vehicle.

Note: SELECT THE CABLE FOR THE RADIO RECEIVER YOU WANT TO INSTALL (TO BE PURCHASED SEPARATELY)

 

• ALPINE
• BECKER
• BLAUPUNKT
• BLAUPUNKT NEW YORK / SONY
• CLARION
• JVC
• JVC KW-AVX
• KENWOOD
• NAKAMICHI / PHILIPS
• LG
• PANASONIC
• PANASONIC AV
• PARROT ASTEROID SMART
• PIONEER
• PIONEER AV
• ZENEC
• UNIVERSAL FOR CHINESE RADIO RECEIVERS